RCU Forums - View Single Post - How to set surfaces after aircraft is trimmed??
Thread: How to set surfaces after aircraft is trimmed??
View Single Post
Old 05-19-2016 | 11:31 AM
  #19  
rgburrill's Avatar
rgburrill
 
Joined: Dec 2010
Posts: 2,910
Received 81 Likes on 72 Posts
From: Dallas, Tx CT
Default
Seems like a lot of work. Why not just pin the control surface, disconnect the pushrod, zero the transmitter and then adjust and reconnect the pushrod.
rgburrill is offline  
Reply Like