RCU Forums - View Single Post - How to set surfaces after aircraft is trimmed??
Thread: How to set surfaces after aircraft is trimmed??
View Single Post
Old 05-19-2016 | 12:06 PM
  #20  
da Rock
Senior Member
 
Joined: Oct 2005
Posts: 11,517
Likes: 0
Received 2 Likes on 2 Posts
From: Near Pfafftown NC
Default
Originally Posted by rgburrill
Seems like a lot of work. Why not just pin the control surface, disconnect the pushrod, zero the transmitter and then adjust and reconnect the pushrod.
Mainly because pinning the surface takes something to pin it with or something to tape it with and pins leave holes and tape..... whatever...

Why not just eyeball? Don't have to remember to bring them and they don't leave marks?
da Rock is offline  
Reply Like