I got to do some trimming yesterday. I moved the CG back a good way just a little at a time until the plane barely has any weight on the nosewheel. It still falls to the canopy in an inverted 45 upline, so I'm going to get a good measurement today and calculate where it actually is on the MAC before moving it anymore. I tweaked the tail until the trim was just barely down before running out of time. I got the aileron differential right so the rolls are very axial and I don't get any yaw when doing a full roll during an upline. The plane flies smoothly through the maneuvers, but still pulls to the canopy in knife edge. I can mix that out if I need to, but I'm still going to experiment to see if I can straighten that out mechanically.