RCU Forums - View Single Post - Finish a Sheeted Q500 Wing
Thread
:
Finish a Sheeted Q500 Wing
View Single Post
08-27-2016, 01:00 PM
#
7
sahartman21
Join Date: Nov 2007
Location: Fritch, TX
Posts: 2,060
Likes: 0
Received 0 Likes on 0 Posts
Finish a Sheeted Q500 Wing
I traced a wing tip from a Sam-Rai on to a lightweight balsa block.
A jig saw was used to cut them out.
Attached Thumbnails
Reply
Like
sahartman21
View Public Profile
Send a private message to sahartman21
Find More Posts by sahartman21
View iTrader Profile