RCU Forums - View Single Post - How to 'glass wing join without clogging torque rods?
Thread: How to 'glass wing join without clogging torque rods?
View Single Post
Old 10-24-2003 | 10:32 PM
  #6  
NOVAflier's Avatar
NOVAflier
Senior Member
My Feedback: (21)
 
Joined: Sep 2002
Posts: 948
Likes: 0
Received 0 Likes on 0 Posts
From: Alexandria, VA
Default RE: How to 'glass wing join without clogging torque rods?
I am glad someone brought this up, because I have a question..

I am going to have to glass a wing set pretty soon on my venture 60. Last time I did this (per the manual) it bubbled all over theplace, and looked like heck.

Can I do it this way (I don't have any spray adhesive). Can I lay down a thinned layer of epoxy on the area I am laying the glass on, then lay the glass on to the epoxy. When it dries, I can then brush on epoxy on top of the glass to saturate it... What do you think?
NOVAflier is offline  
Reply Like