Hello Herc!

I appreciate the report on your break-in procedures! Wow ~ it looks as if it will take some patience only running it for a couple of minutes at a time before the glow battery runs down!

I was going to wait until after my engine break-in to see how it ran without any on-board glow. If it has trouble at that time keeping all cylinders operating I was considering the McDaniel's 7-cylinder on-board glow - but I note that they cost about $150.

One question - What is the Saito carburetor model number that you have on your 7-35? Is it the one that fits the Saito FA-129r3 (SAI90R3821)?

Here’s hoping that your break-in session goes well (and enjoy the sounds).

–DJ

PS: Thanks for the Waco comment - replacing the stock decals with some from Callie Graphics never fails to improve the looks!