RCU Forums - View Single Post - Jeti Spin Pro programming question - setting up the throttle end points.
Thread: Jeti Spin Pro programming question - setting up the throttle end points.
View Single Post
Old 04-19-2017 | 12:14 PM
  #10  
EHFAI
 
Joined: Apr 2003
Posts: 278
Likes: 0
Received 1 Like on 1 Post
From: Katy, TX
Default
I would add one additional step - with the "Throttle Cut" on, set the throttle fail safe. Cycle the TX / RX off - on and verify the throttle pulse goes to the Throttle Cut level when the TX is switched off.
EHFAI is offline  
Reply Like