Well curiosity took the best of me today Will and I measured the incidence on the stabs.
With both elevators flush with the stabs there appears to be .1 degree more incidence on the right ....no big deal really......
This is consistent with elevator levelling i.e. right elevator slightly up in order to be level with left elevator.

Initially when I was trimming there was a very slight corkscrew effect during looping with the elevators flush with the stabs ....this was fixed by levelling the elevators using the Carbon rod method and the corkscrew went away.
Important to note here is that levelling the elevators with the long carbon rods the stabs are not flush with elevators.
The model flies very nicely however with tremendous amount of authority on the rudder but needs to be flown a little faster to maintain longitudinal stability.

Maybe if I didn't have the Carbon rods I would have been none the wiser...

kind regrds

Mavros



kind regards

Mavros