Originally Posted by
aspeed
They need a heat sink head to cool properly in a car. There is no prop flow when it idles. If you can get a clutch on it, and it physically fits, it should be ok.
Yea, that was my primary concern, cooling, would have to either make a custom head or buy another cooling head and make it fit the other, I don't think finding a clutch would be very hard it would just be finding the right clutch spring tension.
Originally Posted by
1QwkSport2.5r
And a .40 is way too big for most cars on the market. You would be much better off selling that Webra to an airplane pilot and buy a proper RC car engine. Seriously.
That would work, I would feel a little bad about doing that but I'll just ask him, maybe I could get into RC planes
Originally Posted by
Hobbsy
I have one of those that needs a piston.
Would you be interested, the piston in this one looks like it was ran lean from my little experience, its a red-brown color on the top, my pistons in my TRX and cen engines were a yellowish grey like they should be. I'll try to clean it up, whats the best way to clean an engine? From what you can see in the pictures is a tiny bit rusty.