RCU Forums - View Single Post - Would this design work?
Thread: Would this design work?
View Single Post
Old 12-16-2017 | 06:51 AM
  #2  
kenh3497's Avatar
kenh3497
 
Joined: Jan 2010
Posts: 1,517
Received 3 Likes on 3 Posts
From: Rockwell, IA
Default
I don't know a lot about EDF or 3D printing but I do know EDF fans run at very high RPM. I would be concerned about the integrity of the fan at those high RPMs. IMO, no use reinventing the wheel when it comes to EDF fans. I would just purchase a proven unit to save on much frustration.

Ken
kenh3497 is offline  
Reply Like