RCU Forums - View Single Post - Hitec "Karbonite" servo's
Thread: Hitec "Karbonite" servo's
View Single Post
Old 10-30-2003, 07:46 PM
  #23  
radray
Senior Member
 
radray's Avatar
 
Join Date: Dec 2002
Location: Hebron, KY
Posts: 221
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Hitec "Karbonite" servo's
Guys with the output shafts braking: were you using the stock servo arms? I am asking because my friend has 5975's (ailerons and elevator) in a beautiful new F86 turbine and Hitec told him just last week if he was using stock Hitec servo arms the 8mm screws were fine.
radray is offline  
Reply Like