RCU Forums - View Single Post - YS 61 R Square Head Rear Exhaust with tuned pipe
Old 04-01-2018, 06:16 PM
  #1  
AlexL
My Feedback: (4)
 
Join Date: May 2004
Location: Thornhill, ON, CANADA
Posts: 81
Likes: 0
Received 0 Likes on 0 Posts
Default YS 61 R Square Head Rear Exhaust with tuned pipe - SOLD

Thank you, the engine is Sold.

Selling a YS 61 R Square head Rear Exhaust nitro engine with tuned pipe.
This engine is off a Summit III F3A pattern plane. It had not been run for couple of years but was protected with tons of after-run oil, and turns freely. I also inspected the bearings and they look clean, however, I am including as set of C-rated bearings, not that the current ones needed changing, but yours as part of the deal. These bearings are hard to come by, you might as well keep it for future use.

Included is a header, and a tuned pipe, well used, and with the typical nitro stain, but still have a lot of mileage, you have to get a new silicon tube coupler though .

Selling as a package, for $100.00 U.S. plus shipping cost.

Thx,

Alex

Last edited by AlexL; 04-04-2018 at 10:23 AM.
AlexL is offline