RCU Forums - View Single Post

04-26-2018 | 08:38 PM

#93

RodneyFord

Joined: Apr 2015

Posts: 424

Likes: 0

Received 1 Like on 1 Post

From: Lower Hutt New zealand

Joined the halves with a strip of 100gm carbon. Not too keen on the brown micro balloons.

94 gms. very stiff and strong. It sustained some damage getting it out of the mold. the first half was OK but the second half not so much. I' m going to do another one and spray some PVA release agent into the mold for an easier release. Would like to lose 20 gms too.

Reply Like