RCU Forums - View Single Post - Shaping Ailerons or Flaps from Solid Balsa Stock.
Thread: Shaping Ailerons or Flaps from Solid Balsa Stock.
View Single Post
Old 05-28-2018 | 05:50 AM
  #2  
carlgrover
 
Joined: Jan 2002
Posts: 836
Received 25 Likes on 23 Posts
From: Decatur, AL
Default
I like to tilt the table on my bandsaw and run the stock through to make mine. I do have to do a little clean up sanding afterwards to remove any saw marks.


carl
carlgrover is offline  
Reply Like