RCU Forums - View Single Post - Shaping Ailerons or Flaps from Solid Balsa Stock.
Thread: Shaping Ailerons or Flaps from Solid Balsa Stock.
View Single Post
Old 11-08-2018 | 07:39 AM
  #14  
Propworn's Avatar
Propworn
My Feedback: (3)
 
Joined: Jul 2002
Posts: 2,489
Received 32 Likes on 26 Posts
From: Canada
Default
I have solid 3 inch by 6 inch light balsa stock 48 inches long and mostly use my table saw set at a calculated angle and rip the ailerons. Depending on use I also use built up ailerons.

Dennis
Propworn is offline  
Reply Like