OK, after much more work I still can't get it to print.

Woz, there are no spaces.

Bob, I'm not using Cura at all for this. The file was created by Martin in Fusion 360, imported to my PC, then loaded to the "3D Creator" software from creality. Unfortunately I'll need someone with more skills than I have to start comparing code.

Donut, I'd really like to see how you do that. When I try, Cura doesn't recognize the LD-001 and won't allow me to select resin as a material, it only has filament settings.

Martin, I haven't quite given up, and if the test file that came with the printer is any indication, this thing (if I can get it to work) is going to improve the quality of stuff like tires and tail light buckets to an entirely new level for us. I really think I can come darn close to Shapeways quality at a fraction of the cost.

So I made this video and sent it to the people at Creality, and now we'll wait for their reply.