So I went to do my first break in yesterday. I had the high speed needle 5 turns out and the low speed at the stock setting. Even at 5 turns out, I was around 6000rpm at full throttle. Has anyone else experienced this? Do I turn the high speed more than 5 turns out or begin to mess with the low speed needle? The manual wait said something about low speed adjustment if high speed didn’t richen it up. I fear I hurt my engine by running the first tank at 6000rpm. That’s the only runtime it’s had though. It appeared to be on the rich side due to the amount of oil coming out the crankcase nipple and amount of smoke I was kicking up. Tank was giving me issues after the first run so that’s all it ran so far. Does anyone have any input on this? What am I doing wrong?