RCU Forums - View Single Post - Building Jig
Thread
:
Building Jig
View Single Post
04-23-2019, 07:01 AM
#
5
foodstick
Join Date: Mar 2005
Location: ankeny, IA
Posts: 5,600
Likes: 0
Received 13 Likes on
11 Posts
Flat board across the bottom (old bed board in my case) Three vertical boards mounted squarely to it. (angle brackets checked with square) make your support rods all the same height off the bottom board . Then its just a matter of making the opening on your bulkheads all on dead center.. Slide the parts on ...
Reply
Like
foodstick
View Public Profile
Send a private message to foodstick
Find More Posts by foodstick
View iTrader Profile