RCU Forums - View Single Post - New 3D printer
Thread: New 3D printer
View Single Post
Old 06-30-2020, 02:15 AM
  #16  
Jarlath
 
Join Date: Jun 2016
Location: Kitchener, ON
Posts: 214
Received 4 Likes on 3 Posts
Default

Originally Posted by Tanque
Oh young grasshopper. My first PC, an original IBM blue cost $3100+ and had 48 k of memory two 5" floppy drives and a boat anchor of a monochrome
tube monitor and dos wasn't just a curious task to run it was the operating system. 1200kb modems were extra and you better know how to interpret the communication protocol because it broke a lot... and this was a hella step up from the Commodore Vic 20 with cassette tape storage..

I had to wait for these 'cause at the time I wasn't adventurous enough to buy a Altair 8800 and put it together...but I drooled over them...

I agree with you 3D printers of a year from now will knock your socks off...

Jerry
LOL... My first PC wasn't as old at that, but I do recall surfing BBS' with a Commodore 64 & a 300 baud modem! Go Dial-up!