RCU Forums - View Single Post - Any Machinist out there ?
Thread
:
Any Machinist out there ?
View Single Post
12-16-2020, 12:01 PM
#
4
jerrybern
Join Date: Dec 2012
Location: , IL
Posts: 212
Likes: 3
Received 33 Likes on
23 Posts
I tried drawing out the trapeze on paper, trying to use the machine dimension and it did not even come close in size, so I assume the decimal conversion to inches I was doing is wrong
Jerry B
Reply
Like
jerrybern
View Public Profile
Send a private message to jerrybern
Find More Posts by jerrybern
View iTrader Profile