RCU was deleting about half of my post. Trying again.


Based on Craig's comment about setting up a stick shaker, I've modified my logic a little.


Set TM Control MX1 for Pump Voltage < 0.01V, enabled by your engine kill switch in the run position

Set TM Control MX2 for EGT>300C, enabled by your engine kill switch in the run position

Set a Logical Switch for MX1 AND MX2

Set an Alarm based on Pump Voltage <=0.01V, activated by the above Logical Switch


Using Alarms allows access to the stick shaker, along with an audio announcement, unlike my previous Sound on Event.


Paul