RCU Forums - View Single Post - Multiple Servo Linkage Geometry
Thread
:
Multiple Servo Linkage Geometry
View Single Post
07-02-2021, 02:16 PM
#
1
Going Balistic
Join Date: Nov 2002
Location: Barrie, ON, CANADA
Posts: 71
Likes: 0
Received 0 Likes on 0 Posts
Multiple Servo Linkage Geometry
Has anyone ever seen or setup linkages like this before? This comes from an extremely well built plane that I purchased a number of years ago and just now getting around to prepping to fly.
The interesting thing is that this plane has a removable tail section and the push rod drives another linkage in the tail that actuates the two externally mounted push rods that are connected to the elevators.
Not sure on the reliability, etc.
The workmanship is impeccable, but a little concerned with all the mechanical aspects and the geometry of the two servos. There is a cap screw on the end of the shaft that will prevent the shaft from coming out of the linkage.
Any feedback / experience would be appreciated.
Reply
Like
Going Balistic
View Public Profile
Send a private message to Going Balistic
Find More Posts by Going Balistic
View iTrader Profile