Thanks Sincraft, that was a quick response. I was almost ready to throw in the towel and buy either a complete ARF wing or a complete LT-40 kit. Your idea is cheaper and good training for an aspiring RC flyer! I especially liked the comment about removing the covering from the area that was formally known as the leading edge. Smartass! I think I'll have to cut one rib out of the good side though. They're all smashed on the right side.

The covering part I'm a bit unclear on though. Would you recommend that I completely strip the one wing and recover? Or, would I just cut away to either the front spar or rear spar and patch from there forward?