RCU Forums - View Single Post - Direct servo connection to control surface question
Thread: Direct servo connection to control surface question
View Single Post
Old 11-17-2003 | 07:55 AM
  #8  
Doug Cronkhite
My Feedback: (34)
 
Joined: Dec 2001
Posts: 3,821
Likes: 0
Received 11 Likes on 8 Posts
From: San Diego, CA
Default RE: Direct servo connection to control surface question
The direct servo setup will be HORRIBLE from a servo resolution standpoint. You're going to have to limit motion to around 30% or less I'm guessing. Not an efficient use of the available servo power.
Doug Cronkhite is offline  
Reply Like