RCU Forums - View Single Post - 1/4 scale or Gang standard servos?
Thread: 1/4 scale or Gang standard servos?
View Single Post
Old 12-10-2003 | 07:51 AM
  #2  
Roby
Senior Member
 
Joined: Feb 2002
Posts: 1,128
Likes: 0
Received 1 Like on 1 Post
From: AMESBURY, MA,
Default RE: 1/4 scale or Gang standard servos?
Personally.............I prefer to keep it clean and simple, the less there is,
the less there is to go wrong,maintain,etc,etc.

I pick "a " servo that meets the requirements and install it...............done !

Regards
Roby
Roby is offline  
Reply Like