I just redid all the elevator linkage today. Changed out dual servos for one single 100 oz/in servo with pull pull cables. Elevator is now dead centered and equal deflection both up and down. Got it set on about 5/8" each way on low rates. Hi rates is about 3/4". Still got to repair the covering where I cut it off to get access but that is minor.
Got all the screws loctited in and everything is tight once again. Tomorrow will tell if it is gonna run right.

I ain't gonna let this sucker beat me.

BTW. The hand is fine, thumb is all healed, a little short but fine. Doesn't affect my flying a bit.

Thanks to all of you for the help.

JimRoss