RCU Forums - View Single Post - Adjusting Reed Value on Ryobi?
Thread: Adjusting Reed Value on Ryobi?
View Single Post
Old 12-31-2003 | 07:43 PM
  #6  
Rejean Boucher's Avatar
Rejean Boucher
Member
 
Joined: Mar 2003
Posts: 51
Likes: 0
Received 0 Likes on 0 Posts
From: Cold Lake, AB, CANADA
Default RE: Adjusting Reed Value on Ryobi?
On both my Ryobi 31CC short shafts, the reed's back stop were already set by the manufacture at 1/8 inch above the reed. Did anyone else take notice to what their gap setting was prior to increasing it?


Rejean
Rejean Boucher is offline  
Reply Like