GP Extra 300S .40 Kit Stab Warp
I am building my first kit, and so far it is going very well. I covered the Stab and Elev early, as these were great practice parts, and easily made from scratch if I screwed them up too badly.
The covering went on well, but I now have a warp in the Stab, and my left Elev is warped up, and the right Elev warped down. I never looked down the leading edges before covering them, but both layed flat on the table, and lined up with all of my straight edges.
I have seen where in other posts where MonoKote may warped the parts, and re-shrinking may be able to take it out. Any tips on doing this? Should I use weights, etc.?
Thanks a million!