Bill,

I have another question for ya.

While flying the other day, I noticed that at hover speed the helicopter had a weird vibration, slow and rythmic(sp?). I made the descision to richen the low end needle a little. This was after the helicopter had been flying so I am sure it was good and hot. Was this the correct thing to do?

Also I noticed that while doing nice easy wide figure 8 patterns after about 7 minutes into the flight the top end would drop off a little. For this I also richened the high speed needle a fraction. and I mean a fraction. This did seem to help smooth out the top end dropping.

Is this the way to go? The plug still looks nice and tan with no appreciable carbon buildup. Both of the adjustments were very very small, I read somewhere that when making a change if you feel it move you wnet to far

I am now trying to find a nice scale body to put on it. It is just begging for one.


Thanks