To all who have given a response,

This is what I'm going to do:

1. Start the engine and allow it to idle for approximately 20 seconds to let it warm.

2. Run up the engine and adjust the needle to a "slightly rich" setting (not four stroke rich). Run the engine at WOT for two minutes. When the two minutes is up, kill the engine and allow it to completely cool.

3. Repeat step No. 2 about 10 times.

4. Lean the needle to normal flying setting and go fly.

Is this correct, yes or no, and if not, what do I need to do differently?

Thanks,
John