RCU Forums - View Single Post - Vee Tail sizing
View Single Post
Old 01-25-2004 | 08:56 PM
  #10  
CoosBayLumber
Senior Member
My Feedback: (1)
 
Joined: Jan 2002
Posts: 3,757
Likes: 0
Received 1 Like on 1 Post
From: San Bernardino Calif
Default RE: Vee Tail sizing

Well, the sweep between the upper surfaces of the Vee tail according to the plan is about 112 degrees. Presume that is within the parameters already noted.

The Butterfly design looks to be a replica of some small home built of the early 1960's

Wm.