I crashed my trainer last fall. I built a new plane. I am trying to use the old engine ev0 46.

It ran fine for the past week or two when taxiing, now it wont run worth a crap.

I have put the low speed needle at 1 1/5 turns and every where around that. I have had the high speed all over the place.

Usually when I increas the throttle it just dies. Then I can mess around with the high speed untill it will rev up to full rpm's, back too idle, seems good. But when I leave it at full throttle more than about 5 seconds it just immediately dies. Any one have any suggestions? I have a feeling if I get any responses it will be common stuff I already tried, but maybe someone will have an idea I havn't tried. If I can't get it straighten out pretty soon I am gonna toss it.

Thanks,

Wings