RCU Forums - View Single Post - Specs for JR4031 servos?
Thread: Specs for JR4031 servos?
View Single Post
Old 05-30-2002 | 09:36 PM
  #4  
jcw111
Senior Member
 
Joined: Dec 2001
Posts: 237
Likes: 0
Received 0 Likes on 0 Posts
From: Phoenix, AZ
Default Specs for JR4031 servos?
I have 4 small books showing all JR servos from about 7 or 8 years ago to the present and see no 4031 designation. There is a 4131 listed which is an older design. If this is what you are looking for specs are as follows

Coreless-----94.4 oz/in torque--------Speed .23 sec/60 deg.-------
Wgt 1.50 oz.

Jim Whitney
jcw111 is offline  
Reply Like