RCU Forums - View Single Post - Aluminum spinner slightly bent ? Is this normal ?
Thread: Aluminum spinner slightly bent ? Is this normal ?
View Single Post
Old 02-02-2004 | 05:04 PM
  #2  
gus
Senior Member
 
Joined: Jan 2003
Posts: 494
Likes: 0
Received 0 Likes on 0 Posts
From: Toronto, ON, CANADA
Default RE: Aluminum spinner slightly bent ? Is this normal ?
No, it is not normal. Anything spinning at 12Krpm that is "not normal" is by default "dangerous".

Can you think of anything that would have damaged the spinner like that?

If so, I would replace the spinner, if not, I would replace it with a different make.

gus
gus is offline  
Reply Like