RCU Forums - View Single Post - Aluminum spinner slightly bent ? Is this normal ?
Thread: Aluminum spinner slightly bent ? Is this normal ?
View Single Post
Old 02-03-2004 | 07:54 PM
  #7  
jrotor's Avatar
jrotor
Senior Member
My Feedback: (5)
 
Joined: Jul 2002
Posts: 304
Likes: 0
Received 0 Likes on 0 Posts
From: San Jose, CA
Default RE: Aluminum spinner slightly bent ? Is this normal ?
Even after much investigation, I still have no idea why the spinner deformed.
The prop was NOT touching the cone NOR the backplate.
I didn't overtighten the screw to bend the backplate.
Worse thing is that MPI stoped responding to my emails. []
jrotor is offline  
Reply Like