RCU Forums - View Single Post - Supporting carbon push rod
Thread: Supporting carbon push rod
View Single Post
Old 02-14-2004 | 03:55 PM
  #1  
mikehannah
 
Joined: Dec 2002
Posts: 896
Likes: 0
Received 0 Likes on 0 Posts
From: Thurso, UNITED KINGDOM
Default Supporting carbon push rod
Hi Folks
I am installing the gear in my MK Skystar and I have a dual elevator coupler at the back and a CF pushrod to connect it too the servo.
Do I need to support the CF pushrod at one or two point to cut down slop?and vibration. if so what is the best way to do it.
I would estimate the distance between the servo and the coupler as just over 24 inchs.

Mike
mikehannah is offline  
Reply Like