RCU Forums - View Single Post - can u knife-edge 3d magic?
Thread: can u knife-edge 3d magic?
View Single Post
Old 02-19-2004 | 10:06 PM
  #12  
Chig's Avatar
Chig
Member
 
Joined: Nov 2003
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
From: Calhoun Falls, SC
Default RE: can u knife-edge 3d magic?
ORIGINAL: fredo

Hi folks
I've just purchased 3D Magic fun fly, and I've read that you can do just about anything with it but can you actualy knife edge this little beast? I'm setting it for 3D and will use OS46fx with APC 12.25x3.75. All comments about this plane are appreciated.
Knife edge is a weak point on the Magic FunFly. It is possible especially if the wind is right to help you but I doubt it will be a regularly enjoyable part of your flying with this plane. However, there is so much else that you can do you probably won't miss it.
Chig is offline  
Reply Like