Well the past winter I have been working on my SIG Kadet Senior (my first plane). I have just finished covering it, and today I was going to take it for a test run, and just taxi it around. So today I glued the stabilizer on. But I noticed that when I glued the elavator on, it is about 1/8" shifted to the left. Not a big deal when it comes to flying, but the color scheme doesn't line up perfect. Then I went to glue the rudder on, and the bottom didn't match up very well so I left it alone. I brought it outside, and when I tried to start it, I was holding onto two pieces of wood on the top, and they both snapped off. Then one of the hinges pulled the wood out of the elavator! So I packed up and went back in.[:@][:@][:@] not to happy either!

If any of you have any opinions or ideas (or any stories of your screw up's) it would be greatly appreciated.