RCU Forums - View Single Post - V-Tail control surface proportioning
Thread: V-Tail control surface proportioning
View Single Post
Old 04-14-2004 | 02:03 PM
  #9  
KLRico
Senior Member
 
Joined: Feb 2004
Posts: 287
Likes: 0
Received 0 Likes on 0 Posts
From: Ramstein AB, AE, GERMANY
Default RE: V-Tail control surface proportioning
That addresses the roll question quite well. Thank you.

Good stuff, these v-tails.[8D]
KLRico is offline  
Reply Like