RCU Forums - View Single Post - Replacing a .40 engine with a .60 in a Trainer
Thread
:
Replacing a .40 engine with a .60 in a Trainer
View Single Post
05-01-2004 | 06:25 PM
#
5
Gringo Flyer
Senior Member
My Feedback: (
18
)
Joined:
Jan 2004
Posts:
2,370
Likes: 0
Received 0 Likes on 0 Posts
From:
Formosa, ARGENTINA
RE: Replacing a .40 engine with a .60 in a Trainer
Why not set the pushrod so that it wont open up 100%? If it were me I think I would end up trying to push it too much so I would have to put a physical limit in order to stop that left thumb!!!
Reply
Like
Gringo Flyer
View Public Profile
Send a private message to Gringo Flyer
Find More Posts by Gringo Flyer
View iTrader Profile
RE: Replacing a .40 engine with a .60 in a Trainer