RCU Forums - View Single Post - pixi programming question
Thread: pixi programming question
View Single Post
Old 05-10-2004 | 05:42 PM
  #12  
RickyT63
Senior Member
 
Joined: Dec 2003
Posts: 167
Likes: 0
Received 0 Likes on 0 Posts
From: San Jose, CA
Default RE: pixi programming question
You need to arm tail ecs at power up. Try the following:
1) Tx power on & throttle at lowest.
2) Connect bat.
3) Pull rudder to left on hold 5-10 seconds (this will reset & arm tail motor).
Let me know.
RickyT63 is offline  
Reply Like