I've done tons of research on these forums. I first decided on a 27% something (cap, extra, edge, etc.) but I figured that getting something a bit smaller would be a better idea (still bigger than a 40 though). I started flying planes at a young age, and I've always wanted to get a big airplane. So now I've jumped back into flying planes again after a few years of not flying airplanes (been flying helis instead . It seems like 3d type flying is all the rage now. I've decided on something in the 0.60 to 1.20 size, and I would prefer a kit. I would'nt mind 4 stroke power either (.91 - 1.20) since I've never had one before. I'm not looking for a profile, even though these seem to be very popular and make it easy to jump into 3ding a plane. From the research I've done I could only find one plane that seems to be full 3d capable, the extreme flight rc yak 55 (not a kit). I've also learned that 3d does'nt mean just being able to torque roll, but being able to execute "high alpha" manuevers. I've looked at every 1.20 size plane that I could find, and it seems like most of them need to be modded to 3d and even then they can't truly 3d. Any suggestions?