RCU Forums - View Single Post - Best 3D servo...
View Single Post
Old 05-28-2004 | 09:59 AM
  #15  
AcroJo's Avatar
AcroJo
Senior Member
My Feedback: (1)
 
Joined: Jan 2003
Posts: 2,279
Likes: 0
Received 0 Likes on 0 Posts
From: Clarks Summit, PA
Default RE: Best 3D servo...

Dig deep Dave, JR d-i-g-i-t-a-l-s you will not regret it. I'd quote you some specs, but your request was too vague. If its a smaller model, then the requirements are less and cost goes down. I do believe that in a community such as Ripley, with its caste conventionalities, if you used anything less than digitals, it would leave your social standing in question. Joe