RCU Forums - View Single Post - LT-40 taildragger conversion problem?
Thread: LT-40 taildragger conversion problem?
View Single Post
Old 06-14-2004 | 10:28 PM
  #1  
RichD's Avatar
RichD
Senior Member
 
Joined: Nov 2003
Posts: 739
Likes: 0
Received 0 Likes on 0 Posts
From: Martinsville, IN
Default LT-40 taildragger conversion problem?
found several threads about how to convert my LT-40 into a taildragger.

Only problem I found is, with this being an ARF, 7 inches inside the tail end of the fuse, is a solid wall. The only thing going through this wall is the elevator nyrod.

Any suggestions on how I can get another nyrod through that wall being 7 inches away?

I could go find a long drillbit, but then how would I epoxy the tube in?

any suggestions?
RichD is offline  
Reply Like