RCU Forums - View Single Post - BVM maverick wing fitting
Thread: BVM maverick wing fitting
View Single Post
Old 06-18-2004 | 08:23 PM
  #1  
maverickflyer
Junior Member
 
Joined: Jun 2003
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
From: philadelphia, PA,
Default BVM maverick wing fitting
I am finishing up a BVM maverick that has been sitting way too long. My quesiton is; how tight should the wings fit the fuse. Should there be any gap? Also should the carbon spars be tight in the wing slots?

Thanks,
Maverickflyer
maverickflyer is offline  
Reply Like