RCU Forums - View Single Post - aeroworks 63" ultimate
View Single Post
Old 06-30-2004 | 05:34 PM
  #47  
AJF--2
Senior Member
My Feedback: (119)
 
Joined: Feb 2002
Posts: 2,089
Likes: 0
Received 1 Like on 1 Post
From: Snow Hill, NC
Default RE: aeroworks 63" ultimate

I test flew mine today with the CG at about the same-- here is what I found. With 3D rates it reminded me of my Pizzaz. Very nice flying and very stable at lower rates and slower speeds: however I do have a concern about the CG or upthrust--or downthrust in this case. When I pulled a 45 upline and rolled inverted the plane climbed stright up in the inverted position--when I rolled upright it would dive a bit until I got back some speed. Stright and level flight was dead on perfect until I rolled inverted and then again it would start an outside loop at a good steep angle. Any ideas??????