RCU Forums - View Single Post - YS63s & 3styla
View Single Post
Old 07-01-2004 | 05:03 AM
  #15  
Welsh3D
Senior Member
 
Joined: May 2002
Posts: 1,140
Likes: 0
Received 0 Likes on 0 Posts
From: Chester, UNITED KINGDOM
Default RE: YS63s & 3styla

The kit contains glass U/C, FG cowl and a plastic canopy plus all the wood and plans for £79. They sell all the other stuff seperately as spares ithink.

Now I would love to be at woodsprings I really would! but i'm off to spain for my summer chill so I can't go.

I've always said it was better than the hype in my opinion. everyone in my club who has 3stylas agrees. however, the Hype is more sedate to fly, a little easier for a novice 3d flier if you wish, more floaty and a lot more draggy... but the 3styla can do so much more.... its one of few models ive seen that can do a 540 stall turn! Surely some of you saw mine at weston park and wings& wheels, the knife edge spins and waterfalls are awesome, some of the most predicatable i've seen.

I haven't flown the new YT stuff but I would guess that the 3styla has the edge over the 3D side of all of them because of the surfaces on them. it's certainly not bad at freestyle stuff too, itll snap reasonably cleanly, good roll rate etc.

All I can say really is that if I didnt fly for RC World, I would still definately have a 3styla in my hangar!