RCU Forums - View Single Post - 9C dual elevator servo programming???
Thread: 9C dual elevator servo programming???
View Single Post
Old 07-03-2004 | 09:57 PM
  #5  
Geistware
Senior Member
My Feedback: (16)
 
Joined: Apr 2002
Posts: 12,942
Likes: 0
Received 0 Likes on 0 Posts
From: Locust Grove, GA
Default RE: 9C dual elevator servo programming???
There would be many uses for the elevator acting like ailerons, the one that I know if is to give or control surface area for roll control.

ORIGINAL: rtn9105
I got it working great, thanks for the help.
Just a quick question, why would you setup your elevators to funtion as ailerons when the aileron stick is moved? Is that like a super snap roll?
Geistware is offline  
Reply Like