I have a Sig 4* with an FMA Direct CPD4 Co-pilot on it. The co-pilot doesn't seem make enough correction or make them fast enough. In set up mode it applys corrections very fast and gives the control surfaces 100% travel but after calibration and during pre-flight check corrections are slow and travel is about 60%. With the co-pilot on during flight it doesn't respond fast enough to apply corrections as needed. I am using a Futaba 6 channel radio & the co-pilot is controled from the flap channel. I would like to know if anyone has had the same experiences with the co-pilot or might know what I am doing wrong.