I would like to try using G10 (G-10)for a body but I have a few questions that I am certain others have already resolved:

1. What thickness is normally used for bodies? (I suspect .25")

2. One picture looked like the G10 was being used to sheet over an inner structure. Is this the normal way it is used?

3. If it is .25" that would seem to be too thin for mounting the wing securely. It would seem to need some form of wing saddle. Could someone explain how your mounting wings using G10. Pictures would be great.

4. How are people cutting this stuff?

5. What do you use for gluing it?

Just a little confused! [&:]

Thanks,
David Sharpe
[email protected]